                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:1306325
IKEA Förnuft Flatware tray by DaHai8 is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

IKEA flatware comes in nice little trays, but they're cardboard and don't last very long. They don't sell a same-sized plastic or wood/bamboo version either. So I replicated it in PLA using Sketchup.
This one is specific to the Förnuft 24 piece set (regionally available): 1 fork, 2 spoons, 1 knife (6 sets)
It was too big to print out in one piece so I had to bisect it and glue the two together.


# Print Settings

Printer: JG Aurora A3 Prusa I3
Rafts: No
Supports: No
Resolution: .2mm
Infill: 15%

Notes: 
Doesn't need any supports and can be a PITA getting it of the print bed because of the large base area.
I printed it with 2 perimeters (.8mm sides, top and bottom) for a little more strength.
Print the 'complete' stl file if it fits on your print bed (22L x 14W x 3.75H). Or print the 'A' and 'B' parts and glue them together.